Hyson Products

Hyson Products PUNCHES & DIES,UNITIZED TOOLING, IRONWORKER TOOLING, PRESSBRAKE TOOLING, DIESETS, DIESET COMPONENTS, DIE SPRINGS, DRILLS, ENDMILLS, TAPS, CUTTING TOOLS, PRESSBRAKES, SHEARS, LASER CUTTING MACHINES, MECHANICAL & HYDRAULIC PUNCH PRESSES, MOLD BASES, MOLD BASE COMPONENTS, MILLING MACHINES, SURFACE GRINDERS, LATHES,DAYTON PROGRESS, SUPERIOR DIE SETS, DANLY IEM, LAMINA, COE PRESS EQUIPMENT, RAPID AIR, HYSON PRODUCTS etc...

Tanker T & S Cylinders(870KB) High force in short heights with contact forces to 15,400 lbs.• Stroke lengths to 225 mm• Dynamic lubrication extends spring life• Bore seal resists contamination and rod damage• Self-aligning piston rod accepts normal die movement and a degree of side load• Nitrided piston rod resists corrosion• Tested to over one million cycles

T3 Highest Force, Shortest Height Gas Springs(765KB)
Twelve-page color brochure describes the highest force, shortest height gas spring on the market today! Now with contact forces to 14,900 lbs. and diameters to 4¾" + Four-page brochure on two newest models with contact forces to 21400 lbs. and diameters to 6 in.

T2 Mini Series Gas Springs (801KB)These mini gas springs with diameters of ¾",1", and 1½", generate from 200lbs. to 595 lbs. contact force. Requiring no preload, one gas spring can easily replace several coiled springs saving die construction cost and reducing the overall size of the tooling. These springs are ideal for use in small transfer dies or anywhere small parts are being made.

T2 SC Series Sub-Compact Gas Springs(691KB)This line of bore sealed subcompact gas springs offers more force capacity in any given size than rod sealed springs. Now available in a one inch diameter, 955 lbs. contact force!

T2 L & LS Low Profile Gas Springs(1578KB)Both the L & LS measure up in applications where shut height is limited. The L installs 1 ¾" shorter than standard gas springs while the LS is a full 2 ¼" shorter. The line has been extended to include the T2LS-300, T2L-1500 and T2L-3000.

T2 B Series Compact Height Gas Springs(757KB)This line of rod sealed gas springs, that meets automotive and appliance standards, is available from ¾ to 8 tons of contact force.

T2-ISO Series(1260KB)Fully meets ISO 11901, NAAMS, Chrysler, Ford and General Motors Die Standards!ISO 9001: 2000 Certified and PED (97/23/EC) Approved. Secondary piston ring assembled onto rod, Guide features built-in pressure relief if assembled upside down, Modular and welded mounts available to meet all automotive die standards.